Free Model Download

Desk Organizer

Pens, paper clips and a pad of sticky notes, each with its own spot, in one piece that takes up 178 × 89 mm of desk. A tall pen cup, a shallow clip tray with a rounded floor and a walled sticky-note bay. It prints upright with no supports, and an optional color band wraps the base.

A black desk organizer with a lime band, its pen cup holding scissors, pens, a highlighter and a marker, its front tray full of paper clips and a pad of sticky notes in the bay beside it

Get the Files

One 3MF with two plates already set up, plus an STL for bringing your own settings. Pick the plate with the color band or the plain one. No hardware, no glue and no assembly.

★
Download from Creality Cloud — it makes a real difference.

Every download through Creality Cloud earns points that help keep my models free and my pages running. If you have an account, downloading from there is the best way to support the work at no cost to you.

Download on Creality Cloud

The 3MF is the faster path — open it, pick a plate and slice. A full print guide is attached to the Creality listing.

▤
Print Guide

The same guide attached to the model listings, hosted here so you can read it before you print — PDF · 4 pages · 522 KB

Open the Guide

A Spot for Everything

Three compartments, each sized for one job, in a single print.

The pen cup loaded with scissors, pens, a highlighter and a marker standing upright
Tall Pen Cup
96.5 mm high, deep enough that scissors, markers and highlighters stand upright instead of tipping out.
Paper clips piled in the shallow tray at the foot of the pen cup
Paper-Clip Tray
A shallow tray at the foot of the pen cup with a rounded floor, so a single clip slides up and out under a fingertip instead of hiding in a corner.
The empty sticky-note bay beside the pen cup, walled on three sides
Sticky-Note Bay
A walled bay beside the cup holds a pad of sticky notes flat and ready to peel.
The organizer standing upright on the build plate with its lime band around the base
Optional Color Band
Plate 1 swaps to a second color from 6.8 to 16 mm for a band around the base. Plate 2 is the same model in one color.

Slice It Right

These are the settings baked into the 3MF, sliced for PLA with a 0.4 mm nozzle. It prints upright with no supports and no brim.

With the color band: 3 h 38 m and 129.43 g, two filament swaps. Without it: 3 h 26 m and 125.53 g, no swaps.

Print it in PLA, PETG or any other filament you like. The 3MF is set up for PLA, and the one in the photos is black and lime PETG. The band is a filament swap from 6.8 to 16 mm, so any two colors work. If your slicer has no Z anti-aliasing setting, just print it without.

Supports
None
Layer Height
0.20 mm
Walls
4
Top / Bottom
5 / 3
Infill
10% Gyroid
Z Anti-Aliasing
On
Material
PLA · 220 °C / 60 °C
Size
177.8 × 88.9 × 96.5 mm
Slice data: with the color band, 3 h 38 m and 129.43 g with two filament swaps; without it, 3 h 26 m and 125.53 g; no supports

More models and tested slicer settings on my Creality Cloud profile.

View Profile

Released under CC BY-NC-ND 4.0 — free for personal use, credit appreciated, no commercial use or derivatives.